Roofing & Exterior
Estimate roof pitch multipliers, roofing squares, shingle bundles, metal panels, seamless gutters, and vinyl siding quantities with editable waste and cost rates.
- Imperial & Metric Unit Toggles
- Editable Waste & Labor Rates
- Instant Client-Side PDF Export
Trade Estimators
Roofing & Exterior Estimators (6)
Select an estimator to calculate quantities, adjust waste/labor rates, and download a PDF estimate.
Roof Replacement Cost Estimator
Calculate sloped roof area from plan footprint and pitch multiplier, roofing squares, tear-off, disposal, and replacement budget.
Commercial Flat Roof Estimator
Estimate membrane area with lap/waste allowance, rigid insulation boards, parapet flashing, drain allowances, and budget.
Metal Roofing Takeoff Calculator
Calculate metal roof panel count from effective coverage width, panel slope length, ridge/eave trim, and fasteners.
Seamless Gutter Cost Calculator
Calculate total gutter linear footage, hidden hangers by spacing, miters/corners, end caps, outlets, downspouts, and removal/installation cost.
Vinyl Siding Takeoff Estimator
Calculate net exterior wall and gable areas, siding squares, boxes/panels, starter strip, J-channel, and corner posts.
Roofing Shingle & Square Calculator
Convert roof dimensions and pitch into roofing squares, field shingle bundles, ridge-cap bundles, and underlayment rolls.
Field & Estimating Methodology
Related Roofing & Exterior Guides
Step-by-step takeoff formulas, waste factor allowances, and safety scope rules.
Support
Roofing & Exterior — Takeoff & Estimating FAQs
Quick answers about how this works, what it assumes, and where its limits are.
How accurate are the Roofing & Exterior material takeoffs on Utilovia?
Every estimator uses deterministic geometry and editable waste, labor, overhead, and tax percentages so you can model material quantities and project budgets clearly (Roof Replacement Cost Estimator, Commercial Flat Roof Estimator, Metal Roofing Takeoff Calculator, Seamless Gutter Cost Calculator, Vinyl Siding Takeoff Estimator, Roofing Shingle & Square Calculator).
Can I switch between Imperial (ft, in, yd³) and Metric (m, cm, m³) units?
Yes. Construction calculators convert dimensions through canonical SI factors so toggling Imperial and Metric updates net volume, coverage area, and unit-cost breakdowns consistently.
Can I export a clean PDF takeoff worksheet without signing up?
Yes. Every Roofing & Exterior calculator renders clean A4 PDF estimate sheets directly inside browser RAM via jsPDF with zero watermarks or uploads.
More Trades
Other Construction Collections
HVAC & Electrical
Preliminary BTU sizing, ductwork takeoffs, heat pumps, panel loads, and voltage drop.
Interior & Concrete
Concrete slabs and footings, drywall installation bids, and painting estimators.
Flooring & Installation
Epoxy floor coating systems and tile flooring, grout, and thinset takeoffs.
Material & Cost Estimators
Cross-category filter across all 18 construction estimators.
